Smeg CWC500R manual Problems And Anomalies User, Possible Cause, Possible Remedy

Finally, turn off the main switch and close the water supply faucet. The detergent and rinse-aid suction tubes will be placed back in the containers when the machine is ready to be put back in use, taking care so as not to invert

the tubes (red tube = detergent; transparent tube = rinse-aid).

Do not leave the device on, inactive and in disuse for long periods of time.

11 PROBLEMS AND ANOMALIES (USER)

PROBLEM	POSSIBLE CAUSE		POSSIBLE REMEDY
THE LED POWER INDICATOR
DOES NOT TURN ON	There is no electrical current		Verify the electrical current connection.
			Wait for the	led indicator to
THE WASH PROGRAM DOES	The dishwasher has not finished
NOT START	loading		turn on
	Sprinkler wash holes are clogged		Disassemble and clean the sprinklers
	or encrusted		(10.2 Periodic checks)
	Detergent or rinse-aid insufficient		Verify detergent type and quantity.
	or not adequate
POOR WASHING RESULTS	Plates / glasses poorly positioned		Arrange plates / glasses accordingly.
	Low wash temperature		Verify the temperature shown on the
			display, if below 50°C call Assistance.
			Increase the duration of the wash
	Inadequate cycle setting		cycle, particularly if dishes are very
			dirty or contain partially dried residues.
	Sprinkler nozzles clogged		Verify the cleanliness of the nozzles
RINSE INSUFFICIENT	Calcium encrustations in	the	and the correct function of any
	boiler		installed water softeners.
	Rinse-aid inadequate or not		Verify the rinse-aid container and
GLASSES AND SILVERWARE	dispensed correctly.		ensure its adequacy for use with the
	Water is of a hardness	level
ARE STAINED			water supply. If the problem persists
	above 12°dF or contains	many
			contact assistance.
	dissolved salts
			Verify that the dishwasher’s tube and
WATER IS PRESENT IN THE	Drainage tube is positioned poorly		drain are not blocked and that the
TANK AFTER DRAINING	or is partially blocked		drain is not in too high of a position;
			see the connection diagram.

13