IMC Networks IE-IMCV operation manual - page 8

4
About iView
2
(iConfig view)
iView
2
(iConfig view) is an in-band utility created by IMC Networks, used for SNMP
configuration for IMC Networks’ SNMP-manageable devices.
The iView
2
(iConfig view) feature allows the following to be performed:
• Set an IP address, subnet mask and default gateway
• Define community strings and SNMP traps
iView
2
(iConfig view) also includes an authorized IP address system and restricted
access to MIB groups which are supported by IMC Networks’ manageable devices.
These extra layers of security do not affect SNMP compatibility. iView
2
(iConfig view)
can upload new versions of the system software and new MIB information. It also
includes diagnostic capabilities for faster resolution of technical support issues.
Installing an IE-iMcV-MultiWay
IE-iMcV-MultiWay should be installed in IMC networks’ unmanaged MediaChassis or
IE-MediaChassis series.
To install an IE-iMcV-MultiWay
1.
Remove the blank bracket covering the slot where the module is to be
installed by removing the screws on the outside edges of the bracket.
2.
Slide the iMcV-Modules into the chassis, via the cardguides, until the
module is seated securely in the connector.
3.
Secure the module to the chassis by tightening the captive screws.
4.
Save any “blanks” removed during installation for future use if the
configuration requirements change.
NOTE
This module is not designed to be installed in an iMediaChassis series with SNMP support.