10
function enables ALL of the traps. To selectively activate and deactivate
traps, use iConfig. iConfig Traps allow greater control using the Trap Edit
than the serial and Telnet does. To choose generic or enterprise-specific
Traps, use iConfig.
Removing Trap Destinations
To remove all trap destinations, press K. Press Y to remove all trap
destinations. Press N to abort and then press Enter.
Change Serial Password
The serial configuration does not have a default password; it is optional.
Password protect the serial configuration process by pressing P from the
main configuration screen. Type the password and press Enter. Passwords
are case sensitive and should be no more than eight characters in length,
with no spaces. This password will be requested whenever logging on or off.
To remove password protection, select P and instead of entering a password,
press Enter.
Enabling/Disabling DHCP
To Enable/Disable DHCP, press D and then type reboot for the changes to
take effect. Refer to page 5 for more information.
Ending a Session
When ending a session, press E before disconnecting the cable in order to
stop the device from continuing to send feedback status through to the serial
port. If a session is not ended properly, the Telnet session cannot be
launched.
Device-Specific Options— Downloading Files
With the iMediaChassis series, firmware can be downloaded from a central
server via a TFTP protocol. Initiate this download via serial configuration or
Telnet session. Make sure the IP Address and the name of the file being
downloaded are correct in the Current Values section of the Main
Configuration screen. To download a file, press the Space Bar in the
Command List section of the Main Configuration screen (serial
configuration). Type download and press Enter to be taken to the
Download a File screen. This screen displays the IP Address of the TFTP
server and the name of the file. Press Enter to start downloading the file.