STEP 12 (See Diagram 12 & Cable Loop Diagram)
A.) Attach one end of the 276” Leg Press Cable (#44) to the open bracket underneath the Left Seat Support (#15). Secure it with one M10 x 1” Allen Bolt (#81), two Ø ¾” Washers (#94), and one M10 Aircraft Nut (#97).
B.) Attach a Pulley to the top opening on the Leg Press Frame (#16). Secure it with one M10 x 2 3/8” Allen Bolt (#84), two Pulley Bushings (#78), and one M10 Aircraft Nut (#97).
C.) Draw the Cable around the Pulley then back to the top opening on the Left Seat Support. Repeat Procedure B above to install a Pulley.
D.) Draw the Cable around the Pulley back to the lower opening on the Leg Press Frame (#16). Repeat Procedure B above to install a Pulley.
E.) Draw the Cable around the Pulley along the Left Base Frame (#14) through the opening on the bottom of Left Vertical Beam (#17) to the first open bracket on the Left Base Frame.
F.) Install a Pulley and secure it with one M10 x 1 ¾” Allen Bolt (#82), one 2 7/8” L- shaped Cable Retainer (#33), two Ø ¾” Washers (#94), and one M10 Aircraft Nut (#97).
G.) Draw the Cable underneath the Pulley then upward to the Angled Double Floating
| Pulley Bracket (#27) previously installed in |
H.) | Draw the Cable around the Pulley then downward to the second open bracket on |
| the Left Base Frame. Install a Pulley with an |
I.) | Draw the Cable upward to the Flat Double Floating Pulley Brackets (#36) previously |
| installed in |
J.) | Draw the Cable around the Pulley then downward to the open bracket on the rear |
| of Left Base Frame. Install a Pulley with a 2 7/8” |
K.) | Draw the Cable underneath the Pulley across the corner to the open bracket on the |
| Right Base Frame (#1). Repeat Procedure J above to install a Pulley. |
L.) | Draw the Cable underneath the Pulley then upward to the Flat Double Floating |
Pulley Bracket (#36) previously installed in
M.) Draw the Cable around the Pulley then downward to the open bracket on the Right Base Frame (#1). Secure the end of the Cable with one M10 x 1” Allen Bolt (#81), two Ø ¾” Washers (#94), and one M10 Aircraft Nut (#97).
N.) Check the tension of the cable loop system. If the cables are too loose, shorten the Short Chain previously installed in Step 11 G.
22
