ASSEMBLY INSTRUCTION
Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches
NOTE: It is strongly recommended two or people assembling this machine to avoid possible injury.
STEP 1 (See Diagram 1)
A.) | Place the Right Base Frame (#31) on a flat surface. Make sure there is enough space |
| around to assemble the machine. |
B.) | Insert four Guide Rods (#16) into the holes on the Right Base Frame. Secure each |
| Guide Rod from bottom with a M10 x ¾” Allen Bolt (#95) and Ø ¾” Washer (#100). |
C.) | Attach four Ø 2 3/8” x 1” Rubber Bumpers (#52) to top of the Guide Rods then slid down |
| to the stopper on the Guide Rods. |
D.) | Attach the Right Vertical Frame (#4) onto the Right Base Frame. Secure it with two M10 |
| x 2 ¾” Carriage Bolts (#98), one 4 ¾” x 2 ¾” Bracket (#25), two Ø ¾” Washers (#100), |
| and two M10 Aircraft Nuts (#102). |
E.) | Attach the Butterfly Base (#13) to the Right Base Frame (#31). Attach the Front Base |
| Frame (#12) to the Butterfly Base (#13) from the front. Align the holes and secure them |
| together with two M10 x 3 ¾” Carriage Bolts (#97) from side, two M10 x 2 ¾” Carriage |
| Bolts (#98) from the bottom, four Ø ¾” Washers (#100), and four M10 Aircraft Nuts |
| (#102). |
F.) | Slide fourteen Weight Plates (#80) onto the rear set of Guide Rods. Make sure the |
| groove on the plates all face toward the back of the machine. |
G.) | Insert a Selector Rod (#28) into the center holes. Slide a Selector Stem (#81) onto the |
| two Guide Rods. |
H.) | Insert a Weight Selector Pin (#74) to select the number of weight plates. Each Weight |
| Plate weights approximately 10 lbs. Please refer to the Weight Resistance Chart in page |
| 35. |
I.) | Repeat procedures F, G and H above to install the other fourteen Weight Plates onto the |
| front two Guide Rods. |
J.) | Attach the Foot Plate (#17) to the Front Base Frame (#12). Secure it with the Foot Plate |
| Axle (#18). |
7
