STEP 4 (See Diagram 4)
A.) Attach the Leg Developer (#14) to the Leg Developer Holder (#5). Secure it with an Axle (#39), two M10 x 5/8” Allen Bolts (#47), and two Ø ¾” Washers (#52).
B.) Insert one Foam Tube (#12) halfway through the hole on the Leg Developer Holder. Insert two Foam Tubes halfway through the holes on the Leg Developer.
C.) Push six Foam Rolls (#37) onto the Tubes from both ends. Plug six Foam Roll End Caps (#32) into the ends.
D.) Attach the Curl Bar Handle Support (#15) to the bracket on the Leg Developer and secure it with a 3”
E.) Attach an Olympic Sleeve (#36) onto the weight post on the Leg Developer. Secure it with a M8 x ½” Allen Screw (#55). Attach a Spring Clip (#25) to the Sleeve.
DIAGRAM 4
7
