Impex PM-3200 manual Securely tighten all Nuts and Bolts previously installed

STEP 2 (See Diagram 2)

A.) Do not tighten Nuts and Bolts until instructed to do so.

B.) Slide the 14 Weight Plates (#34) onto the Guide Rods (#13). Make sure the deep grooves on the Plates are all facing down and toward back of the machine. If the locking holes on the guide rods are more than 2-3 inches from the upper most, then you have installed the Guide Rods upside down. Align the holes of the Weight Plates. Insert the Selector Rod (#14) through the center hole. Slide the ring on the L-shaped Weight Selector Pin (#65) onto the Selector Rod. Use the L-shaped Weight Selector Pin to select the number of Plates to exercise. Please refer Weight Resistance Chart in page 24.

C.) Slide the Selector Stem (#33) onto the Guide Rods.

D.) Attach the Upper Frame (#4) to the two Guide Rods. Place the Upper Frame onto the Front Vertical Frame (#3).

E.) Secure the Upper Frame to the Guide Rods with two M10 x 1” Allen Bolts (#73) and two Ø ¾” Washers (#84).

F.) Secure the Upper Frame to the Front Vertical Frame with two M10 x 3 ½” Carriage Bolts (#78), one 5 ½” x 2” Bracket (#21), two Ø ¾” Washers (#84), and two M10 Aircraft Nuts (#83).

G.)Securely tighten all Nuts and Bolts previously installed in Step-1 and Step-2.

9