ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches, two Allen
Wrenches, and one Philips Screwdriver. NOTE: It is strongly recommended this machine to be assembled by two or more people to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Push two Ø 2 3/8” x 1” Rubber Bumpers (#43) onto the Guide Rods (#13) from the bottom. Insert the Guide Rods into the holes on the Rear Base Frame (#2). The Guide Rods have holes on the rods about 2/3 way down the rods: for locking the weight stack when not in use. The shorter end of the Guide Rod with the lock holes need to be pointed downwards towards the Rear Base Frame.
B.) Secure them with two M10 x 1” Allen Bolts (#73) and two Ø ¾” Washers (#84) from the bottom of the Rear Base Frame.
C.) Do not tighten Nuts and Bolts starting from next step until instructed to do so.
D.) Attach the Front Vertical Frame (#3) to the Base Frame (#5). Secure it with two M10 x 3 ½” Carriage Bolts (#78), one 5 ½” x 2” Bracket (#21), two Ø ¾” Washers (#84), and two M10 Aircraft Nuts (#83) from bottom.
E.) Connect the Base Frame to the Rear Base Frame (#2). Secure it with two M10 x 2 ¾” Carriage Bolts (#80), one 4 3/8” x 3” Bracket (#29), two Ø ¾” Washers (#84), and two M10 Aircraft Nuts (#83).
7
