A.) | Attach a ∅ ¾” Washer (#3) onto a M10 x 6 ¼” Hex Bolt (#54). Insert the Bolt through |
| the Butterfly (#17). Place a M10 Regular Nut (#57) onto the Bolt. Then insert the Bolt |
| through the hole on the Rear Upright Beam (#1). Secure the Bolt with a Lock Knob (#8) |
| behind the Upright Beam. Repeat the same step to install the other Butterfly. |
B.) | Attach the Right Butterfly Handle (#56) to the Right Butterfly (#17). Secure it with a M10 |
| x 2 ½” Carriage Bolt (#16), ∅ ¾” Washer (#3), and M10 Aircraft Nut (#4). Repeat the |
| same step to install the other side. |
C.) | Attach the Leg Developer (#38) onto the bracket on the Front Stabilizer (#42). Secure it |
| with a Hex Socket Axle (#44) and Hex Socket Screw (#45). |
D.) | Insert two Foam Roll Tubes (#39) halfway through the hole on the Leg Developer (#38). |
| Push four Foam Rolls (#37) onto the tube from both sides. |
E.) | Place three Spring Clips (#34) onto the post on the Leg Developer and Butterfly. |
| DIAGRAM 3 |
6
STEP 4 (SEE DIAGRAM 4)
