Indesit FE 10 K GB manual Unpacking, Installation of Built-in Ovens, Electrical connection

Installation

Important: The power supply to the appliance must be cut off before any adjustments or maintenance work is done on it.

Unpacking

Remove the outer packing from the oven. Open the door outwards and remove packing from the shelves. Take out the plastic envelope containing instruction book, guarantee card and 4 fixing screws.

Installation of Built-in Ovens

In order to insure that the built-in appliance functions properly, the cabinet containing it must be appropriate. The figure below gives the dimensions of the cutout for installation under the counter or in a cabinet wall unit.

.	45	mm.
mm
560

To fasten the oven to the cabinet, open the door of the oven and fasten it by inserting the 4 wood screws into the 4 holes locate on the perimeter of the frame.

595 mm.	23 mm.
	567 mm.
	5 mm.

595	mm.		.
		543	mm
	.
	mm
20

	.	mm.
45	mm

558 mm. 593

	.
45	mm
	.
min

The panels of the adjacent cabinets must be made of heat resistant material. In particular, cabinets with a veneer exterior must be assembled with glues able to withstand temperatures of up to 100° C.

Once the appliance has been installed, the electrical parts must be totally protected from all contact, according to current safety regulations.

All protecting parts should be firmly fixed and should require the use of a tool for removal.

When installing below a built-in hob, ensure that there are air inlets and outlets for ventilating the interior of the cabinet adequately. Assembly examples are given in figs.

595 mm.	23 mm.
	567 mm.
	5 mm.

595	mm.		.
		543	mm
	.
	mm
20

558 mm.

-585 mm.	595 mm.
575

	.
	mm
45	.
	min

Electrical connection

Ovens with a three-pole power supply cable are designed to operate with alternated current at the supply frequency and voltage indicated on the data plate (at the bottom of

In order to ensure adequate ventilation, the back panel of the cabinet must be removed. Installing the oven so that it rests on two strips of wood is preferable. In the case where the oven rests on a continuous, flat surface, there must be an aperture of at least 45 x 560 mm.

the oven dashboard). The earthing conductor of the cable is the yellow-green conductor.

Two types of connection are provided:

Connection n° 1

Connecting the power supply cable to the mains.

Fit a normalized plug to the cable, which corresponds to the load indicated on the data plate; if the cooker is connected directly to the mains, an omnipolar circuit-

4