3. Confirm by pressing the 
button.
To cancel a programme, follow the above
instructions. At step 2, press the - button: the
duration decreases progressively until it reaches 0 and switches off. The programme resets and the display exits programming mode.
Timer
The hob must be switched on.
The timer can be used to set a duration up to 99 minutes.
1.Press the 
programming button until the timer indicator light is illuminated. 
2.Set the desired duration using the - and + buttons.
3.Confirm by pressing the 
button.
The timer begins counting down immediately. When the time has elapsed, a buzzer will sound (for one minute).
Control panel lock
When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children,
during cleaning, etc.). Press the | button to lock |
the control panel: the indicator light above the button will switch on.
To use any of the controls (e.g. to stop cooking), you
must switch off this function. Press the | button |
for a few moments, the indicator light will switch off and the lock function will be removed.
Switching off the hob
Press the |
| button to switch the appliance off. |
|
If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function.
“Demo” mode
It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the “demo” mode the hob must be switched on, with all the hotplates switched off.
• Press and hold the + and - buttons
simultaneously for 6 seconds. When the 6 seconds have elapsed, the ON/OFF and
CONTROLS LOCKED indicator lights will flash for GB one second. Release the + and - buttons and
press the 
button;
•The display will show the text DE and MO and the hob will be switched off.
•When the hob is switched on again it will be set to the “demo” mode.
To exit this mode, follow the procedure described above. The display will show the text DE and OF and the hob will be switched off. When it is next switched on, the hob will function normally.
Practical advice on using the appliance
!Use cookware made from materials which are compatible with the induction principle (ferromagnetic material). We especially recommend pans made from: cast iron, coated steel or special stainless steel adapted for induction. Use a magnet to test the compatibility of the cookware.
SUITABLE | UNSUITABLE |
* | Copper, |
Cast iron | |
Enamelled steel | Aluminium, Glass, Earthenware, |
Special stainless steel Ceramic, non magnetic Stainless steel
In addition, to obtain the best results from your hob:
•Use pans with a thick, flat base in order to fully utilise the cooking zone.
•Always use pans with a diameter which is large enough to cover the hotplate fully, in order to use all the available heat.
•Make sure that the base of the cookware is always clean and dry, in order to fully utilise and extend the life of both the cooking zones and the cookware.
•Avoid using the same cookware which has been used on gas burners: the heat concentration on gas burners may distort the base of the pan, causing it not to adhere correctly.
12
