Indesit I6I6C6A manual Installation, Positioning and levelling, Electrical connection, Levelling

Installation

!Please keep this instruction booklet in a safe place

GB for future reference.. Make sure the booklet remains with the appliance if it is sold, given away or moved.

!Please read this manual carefully: it contains important information on installation, operation and safety.

!The appliance must be installed by a qualified professional in accordance with the instructions provided.

!Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply.

Positioning and levelling

!The appliance may be installed alongside any cupboards whose height does not exceed that of the hob surface.

!Make sure that the wall which is in contact with the back of the appliance is made from a non- flammable, heat-resistant material (T 90°C).

To install the appliance correctly:

•Place it in the kitchen, the dining room or the studio flat (not in the bathroom).

•If the top of the hob is higher than the cupboards, the appliance must be installed at least 600 mm away from them.

•If the cooker is installed underneath a wall cabinet, there must be a minimum distance of 420 mm between this cabinet and the top of the hob.

				This distance should
HOOD				be increased to 700
				mm if the wall cabinets
Min. 600 mm.		min. 650 mm. with hood	min. 700 mm. without hood	are flammable (see
Min. 420 mm.	Min. 420 mm.			figure).
				• Do not position
				blinds behind the
				cooker or less than 200
				mm away from its
				sides.

•Any hoods must be installed in accordance with the instructions listed in the relevant operating manual.

Levelling

If it is necessary to level the appliance, screw the adjustable feet into the positions provided on each corner of the base of the cooker (see figure).

The legs* fit into the slots on the underside of the base of the cooker.

Electrical connection

Fitting the power supply cable

To open the terminal board:

• Insert a screwdriver into the side tabs of the terminal board cover.

• Pull the cover to open it.

To install the cable, follow the instructions below:

• Loosen the cable clamp screw and the wire contact screws.

!The jumpers are pre-set at the Factory for 230 V single-phase connection (see figure).

230V ~ H05RR-F/ 3x4 CEI-UNEL 35363 H05VV-F/ 3x4 CEI-UNEL 35746

N L

5 3 1

4 2

•To carry out the electrical connections as shown in the figures, use the two jumpers inside the box (see figure - labelled “P”).

		P
N	L1
	L2	L3

3