Indesit IS50D1 Start-up and use, Using the hob, Using the oven, Lighting the burners

Start-up and use

Using the hob

GB

Lighting the burners

For each BURNER knob there is a complete ring showing the strength of the flame for the relevant burner.

To light one of the burners on the hob:

1.Bring a flame or gas lighter close to the burner.

2.Press the BURNER knob and turn it in an anticlockwise direction so that it is pointing to the maximum flame setting E.

3.Adjust the intensity of the flame to the desired level by turning the BURNER knob in an anticlockwise direction. This may be the minimum setting C, the maximum setting E or any position in between the two.

If the appliance is fitted with an electronic lighting device* (see figure), press the ignition button,

marked with the symbol 1, then hold the BURNER

knob down and turn it in an anticlockwise direction, towards the maximum flame setting, until the burner is lit. The burner may be extinguished when the knob is released. If this occurs, repeat the operation, holding the knob down for a longer period of time.

!If the flame is accidentally extinguished, switch off the burner and wait for at least 1 minute before attempting to relight it.

If the appliance is equipped with a flame failure safety device*, press and hold the BURNER knob for approximately 3-7 seconds to keep the flame alight and to activate the device.*

To switch the burner off, turn the knob until it reaches the stop position •.

HOB GAS BURNER

SAFETY DEVICE

ELECTRONIC

LIGHTING DEVICE

Practical advice on using the burners

For the burners to work in the most efficient way possible and to save on the amount of gas

￿￿￿￿￿￿	￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿
￿￿￿￿￿￿￿￿	￿￿￿￿￿￿￿
￿￿￿￿￿￿￿￿￿￿￿￿￿	￿￿￿￿￿￿￿
￿￿￿￿￿￿￿￿￿￿￿￿￿	￿￿￿￿￿￿￿

consumed, it is recommended that only pans that have a lid and a flat base are used. They should also be suited to the size of the burner.

To identify the type of burner, please refer to the diagrams contained in the “Burner and nozzle specifications”.

Using the oven

!The first time you use your appliance, heat the empty oven with its door closed at its maximum temperature for at least half an hour. Ensure that the room is well ventilated before switching the oven off and opening the oven door. The appliance may emit a slightly unpleasant odour caused by protective substances used during the manufacturing process burning away.

!Before operating the product, remove all plastic film from the sides of the appliance.

1.Select the desired cooking mode by turning the SELECTOR knob.

2.Select the recommended temperature for the cooking mode or the desired temperature by turning the THERMOSTAT knob.

A list detailing cooking modes and suggested cooking temperatures can be found in the relevant table (see Oven cooking advice table).

During cooking it is always possible to:

•Change the cooking mode by turning the SELECTOR knob.

•Change the temperature by turning the THERMOSTAT knob.

•Set the total cooking time and the cooking end time (see below).

•Stop cooking by turning the SELECTOR knob to the “0” position.

!Never put objects directly on the bottom of the oven; this will avoid the enamel coating being damaged. Only use position 1 in the oven when cooking with the rotisserie spit.

!Always place cookware on the rack(s) provided.

8