c)Minimum regulation of the hob burners:
• turn the tap to minimum;
• remove the knob and adjust the regulation screw, which is positioned in or next to the tap pin, until the flame is small but steady.
N.B.: in the case of liquid gas, the regulation screw must be screwed in to the bottom.
• check that the flame does not turn off when you turn the tap quickly from high to low.
d)Regulating the primary air of the burners:
The primary air of the burners requires no regulation.
Adapting the gas oven to different types of gas
a) | Replacing the oven burner nozzle: |
• | remove the warming drawer; |
• | remove the sliding protection “A” (see Fig.C); |
• | remove the screw and then the oven burner “V”(see |
| Fig. D). Remove the oven door to facilitate this |
| operation. |
• | unscrew the oven burner nozzle using the special |
Adapting the gas grill to different types of gas Replacing the nozzle of the grill burner:
•remove the screw and then slide out the grill burner “V” (see Fig. F);
•unscrew the grill burner nozzle using the special socket spanner for the nozzles (see Fig. G) or better still a 7 mm socket spanner;replace the nozzle with a nozzle for the new type of gas (see table 1).
socket spanner for the nozzles (see Fig. E), or better |
still a 7 mm socket spanner, and replace it with a nozzle |
suited to the new type of gas (see table 1). |
V
V |
I |
A
Fig. C | Fig. D |
Fig.E
b)Minimum regulation of the gas oven burner with thermostat (see fig.):
•light the burner as described in the paragraph “the oven knob” of the instruction booklet.
•turn the knob to Max for about 10 minutes and then turn the knob to the Min setting;
•remove the knob;
•regulate the screw positioned outside the thermostat pin until the flame is small but steady.
N.B.: in the case of liquid gas, the regulation screw must be screwed in to the bottom.
Fig. FFig. G
Pay particular attention to the plug wires and thermocouple tubes.
Important
On completion of the operation, replace the old rating sticker with one indicating the new type of gas used. This sticker is available from our Service Centres.
Note
Should the pressure of the gas used be different (or vary) from the recommended pressure, it is necessary to fit a suitable pressure regulator onto the inlet pipe in compliance with current National Regulations relative to “regulators for channelled gas”.
6
