Indesit SAN 400, SAN 300, SAAN 300 manual Troubleshooting, Malfunctions, Possible causes / Solutions

Models: SAN 400 SAN 400 S SAAN 300 SAN 300

1 12
Download 12 pages 30.16 Kb
Page 11
Image 11
Troubleshooting

Troubleshooting

If the appliance does not work, before calling for Assistance (see Assistance), check for a solution from the following list.

Malfunctions:

Possible causes / Solutions:

GB

The internal light does not illuminate.

The refrigerator do not cool well.

The food inside the refrigerator is beginning to freeze.

The AIR fan does not rotate.

The motor runs continuously.

The appliance makes a lot of noise.

The plug has not been inserted into the electrical socket, or not far enough to make contact, or there is no power in the house.

The door do not close properly or the seals are damaged.

The door are opened too frequently.

The TEMPERATURE ADJUSTMENT knob is not in the correct position

The refrigerator have been over-filled.

The TEMPERATURE ADJUSTMENT knob is not in the correct position.

The food is in contact with the back inside wall of the refrigerator.

The refrigerator door is open.

The AIR system is only activated automatically when it becomes necessary to restore perfect operational conditions inside the refrigerator compartment.

The door is not closed properly or is continuously opened.

The outside ambient temperature is very high.

The appliance has not been installed on a level surface (see Installation).

The appliance has been installed between cabinets that vibrate and make noise.

The internal refrigerant makes a slight noise even when the compressor is off. This is not a defect, it is normal.

The back wall of the refrigerator unit is covered in frost or droplets of water

There is water at the bottom of the refrigerator.

This shows the appliance is operating normally.

The water discharge hole is blocked (see Maintenance).

11

Page 11
Image 11
Indesit SAN 400 manual Troubleshooting, Malfunctions, Possible causes / Solutions, The internal light does not illuminate