Keeping Your Appliance in Shape
Before doing any cleaning, disconnect the appliance from the electricity (by pulling out the plug or turning off the general switch in your home).
Holiday Function
Mould and bad odours forming inside your unused refrigerator when you go on holiday, need no longer be a problem. Just enable the Holiday function. By turning the freezer compartment temperature adjustment knob on to the symbol HOLIDAY, the freezer compartment will continue to operate at a tem- perature of
onto the symbol 
, the fridge compartment will
operate at a temperature of ca. +11°C. (You can store your
Cleaning and maintenance
Always unplug the appliance from the mains before cleaning.
-Your appliance is manufactured with hygienic odourless materials. To preserve these characteristics, always use sealed containers for strong smelling foods to avoid the formation of odours that are difficult to remove.
-Use only a water and bicarbonate solution: Clean the internal and exterior of your appliance with a sponge soaked with a warm water and sodium bicarbonate solution, which is also a good disinfectant. If you do not have any sodium bicarbonate at home, use neutral detergent.
-What not to use: Do not use abrasive detergents, bleach or detergents containing ammonia. Never use solvent based products.
-All the removable parts can be cleaned by soaking in hot soapy water or detergent. Remember to dry thoroughly before replacing them.
-What about the back panel? Dust may deposit on the back panel and affect the proper running of the appliance. To remove dust, vacuum away the dust very carefully using the appropriate vacuum cleaner accessory.
-Discontinued use of the appliance: If the appliance is not in use for any length of time, remember to clean the interior and dry thoroughly, leaving the doors open to prevent the formation of bad odours and mould.
-How to replace the internal lamp. The lamp for the internal light is situated at the rear of the thermostat box. To replace it, disconnect the appliance from the electricity mains, unscrew the burned out bulb and replace it with another bulb with a wattage no higher than 10 Watt, follow the instructions illustrated in fig. 4.
Fig. 4
GB | 10 |
