Indesit WD 12 X manual Temperature control knob, Drying cycle knob, Detergent dispenser, Easy iron

Understanding the control panel

Here I’m in command

Making the right choice is important. And it’s easy. E F G H I L

D

C BA

Programme selector knob Use this knob to select the wash programme.

Turn this knob clockwise only. To select a programme, you should turn the knob so that the symbol/number of the desired programme is in line with the pointer on the knob.

Now press on/off button H (position I), pilot lamp I will start flashing.

After 5", the setting will be accepted, pilot lamp I will stop flashing (staying lit) and the wash cycle will begin.

Should you wish to interrupt the programme in progress or set a new one, select one of the symbols (Stop/Reset) and wait 5" : when the cancellation has been accepted, pilot lamp I flashes, and you can then turn the appliance off.

After the wash cycle has been set and accepted by the washer- dryer, turning the knob will have no effect (except for when it is on position Stop/Reset).

Temperature control knob

It is used to set the wash tempe- rature in the recommended programme table on pag. 4. It also allows you to reduce the tempe- rature recommended for the selected programme, and even to set a cold wash cycle ().

Drying cycle knob

Use this knob to select the desired drying cycle. Two options are available:

A - Based on time: From 40 minutes to 150.

B - Based on the damp level of the dry clothes:

Iron :slightly damp clothes, easy to iron.

Wardrobe : dry clothes to put away.

Extra dry : very dry clothes, recommended for towelling and bathrobes.

A cooling stage is foreseen at the end of the drying cycle.

Detergent dispenser

It is divided into 3 compartments:

1.Detergent for pre-wash;

2.Detergent for the main cycle wash;

3.Fabric conditioner.

The washer-dryer is equipped with an extra compartment 4 (provided as an accessory) for the bleach, to be inserted in compartment 1.

Easy iron

This function allows your washing to come out of the machine without creases, making it much easier to iron.

You can use it with programmes 3-4(Cotton), 5-6-7(Synthetics) and 9-10(Delicates).

Press this button in programmes 5-6-7-9-10and the wash cycle will come to a stop on symbol .You can comple- te it by pressing button E again.

Notes:

-this function should not be used when button G (stain removal) has been pressed.

-If you also want to run the drying cycle, this button is enabled only if combined with

level (Iron).

Slow spin

Use this button to reduce the spinning speed from 1200 to 600 rpm for the cotton and linen programmes and from 850 to 600 rpm for the synthetic fabrics programmes.

On-off

When button H is pressed, the washer-dryer is switched on, when it is not the machine is switched off.

Turning the appliance off does not cancel the selected programme.

On-off lamp / door locked Lamp I flashes slowly when the appliance is switched on and awaiting instructions and at the end of a cycle, indicating that the door can be opened. It flashes quickly when the door should not be opened. A steady light means the appliance has accepted the selected programme.

Drying cycle lamp

When this lamp is on, it means that knob C has been set on a drying cycle and at the end of the wash cycle, the appliance will run the selected tumble drying cycle.

The detergent dispenser with the additional bleach compartment is here.

4

1

2

3

Stain removal (see page 8)

Thanks to this command, the washer-dryer will carry out a more intensive wash that optimises the effectiveness of the liquid additives, thus allowing more resistant stains to be removed. When you press the stain removal button, you cannot activate the pre-wash.

3Instructions for installation and use