INSTALLATION
CONNECTIONS
Figure 5A. Mounting the tweeter using the | Figure 6. Mounting the tweeter using the |
| ||
|
|
|
| |
blk | – | blk | – | |
| + | |||
+ | red | |||
red |
| |||
| 1 |
| ||
|
|
| ||
1) push in
2
2) turn
Figure 5B. Aiming the tweeter at a desired listening position.
3
ROTATE TO AIM
ANGLED TWEETER
TOWARD LISTENER.
1
Open the crossover housing by placing your fingers between the terminals and the top cover, and gently pulling off the cover. Using screws or a wire tie, mount the crossover through the holes provided. Observing proper polarity, connect the speakers and amplifier as shown in 7A and 7B. Replace the cover when you are finished making connections and adjustments.
Figure 7A. Wiring connections on the crossover network (shown with cover on).
| |
Red
To AMPLIFIER
SPEAKER OUTPUTS To WOOFER Blk ToTWEETER
Infinity Kappa component crossovers include a “Custom Contour™” adjustment. Custom Contour, if enabled, will reduce the midrange output from the system, resulting in more perceived bass and high frequency.You may choose the setting that best suits your listening perference.The default position is “Flat”.
Figure 7C. Enable Custom Contour by moving the jumper (located in the upper-left corner, inside the crossover housing) to connect the two left pins.
Defeat Custom Contour by moving the jumper to connect the two right pins.
ContourContour
FlatFlat
FlatContour
SLIDE SCREW UP OR
DOWN TO ADJUST
TWEETER ANGLE.
2
TIGHTEN NUT AND
WASHER TO LOCK
ANGLE SETTINGS.
4
SECURELY TIGHTEN
THE LARGE HAND NUT.
Figure 7B. Locating wiring connections on the 50.5cs woofer. Other woofers are wired similarly.
Big Lug =
Small Lug =
- 3 -
