Shutting down the projector
Auto Off Time
The projector also has an Auto Off Time feature that automatically turns the projector off after no active sources are detected and no user interaction with the projector is performed for 30 minutes. By default, this feature is off. You can change the length of time, see page 29.
Turning off the projector
To turn the projector off, press the Power button on the remote or keypad. The lamp turns off and the Power LED blinks blue for 30 seconds while the fans continue to run to cool the lamp. If the Power Saving Mode feature is on and when the lamp has cooled, the LED lights blue and the fans stop. If the Power Saving Mode feature is off and when the lamp has cooled, the LED blinks blue and the fans stop. Unplug the power cable to completely power off the projector.
Troubleshooting your setup
If your image appears correctly on the screen, skip to the next section. If it does not, troubleshoot the setup.
The Status Indicator Lights on top of the projector indicates the state of the projector and can help you troubleshoot.
Table 4: Status Indicator Lights
Status Indicator Light | Meaning | ||
|
|
| |
POWER: Solid Blue | 1. | If the Power Saving Mode feature is on, | |
TEMP: Off | the projector is plugged in. | ||
LAMP: Off | 2. | The projector is on and initialized. | |
| 3. | The projector is in normal operation. | |
POWER: Blinking Blue | 1. | If the Power Saving Mode is off, the | |
TEMP: Off | projector is plugged in. | ||
LAMP: Off | 2. | The projector is powering down and | |
| the fans are cooling the projector. | ||
|
| ||
POWER: Blinking blue | The projector fan(s) are not operating | ||
TEMP: Blinking red | correctly and the projector has been shut | ||
LAMP: Blinking red | down. | ||
POWER: Solid blue | The lamp failed to ignite. | ||
Contact Technical Support if the problem | |||
TEMP: Blinking red | |||
persists. Visit www.infocus.com/support | |||
LAMP: Blinking red | |||
to contact service. | |||
| |||
|
| ||
POWER: Solid blue | The lamp has reached its end of life and | ||
TEMP: Blinking red | must be replaced. The lamp will continue | ||
LAMP: Blinking red | to operate untils it fails. | ||
| Contact Technical Support. Repair may be | ||
| needed. | ||
|
|
| |
POWER: Solid blue | 1. | The projector is overheating and the | |
TEMP: Blinking blue | lamp will be shut off. The fans will | ||
LAMP: Blinking blue | continue to run. | ||
| 2. | The projector will not turn back on | |
| until the cooling process is complete. | ||
|
|
| |
11
