Page 11INF5520 Hardware Guide
4) Align the rectangular brackets with the screw holes on the tablet and using the screws from Step 3, secure the sound bar
against the boom edge of the tablet.
5) Connect one end of the AC power cord to the AC In jack on the back of the sound bar.
6) Connect the other end of the AC power cord to the AC Out jack on the Boom Connector Panel of the tablet.
7) Plug the sound bar’s audio cable into the Audio Out (RCA R/L) jack on the Side Connector Panel located on the back of the
tablet.
8) Turn the power switch ON.
9) Route the power cord and audio cable through the large bracket and align the bracket against the back side of the tablet and
sound bar.
10) Fasten the bracket securely to the tablet and sound bar with the four remaining screws.
Setup

Attaching the Sound Bar

NOTE: If you are not aaching the sound bar, proceed to the next secon, “Installing the Feet” on page 12.
1) Carefully place your tablet face-down on a clean, cushioned surface with the top edge hanging o of the cushioned surface by
4-5” (10-13cm). Do NOT place the INF5520 on its back.
2) Aach the two small rectangular brackets to the sound bar with the provided screws as shown below.
3) Remove four screws from the back of Mondopad as shown below.
Power Switch