InFocus infocus single stud short throw wall mount manual Pitch Adjustment, Removing Mount Covers

Installation Instructions							PRJ-WALLKIT-11
Pitch Adjustment
NOTE: Pitch can be adjusted using the projector mount or the
	pitch of the entire arm can be adjusted. See Pitch
	Adjustment - Entire Arm section for details.
1. Loosen Pitch adjustment locking screw using a #2 Phillips
	screwdriver. (See Figure 19)
2. Turn Pitch micro-adjustment screw right or left using a #2							2
	Phillips screwdriver until image is properly aligned on target.
	(See Figure 19)
3. Tighten Pitch adjustment locking screw using a #2 Phillips
	screwdriver. (See Figure 19)
					1	3
						2
	2	1	3			Figure 20
			Removing Mount Covers
			1.	Remove two #8 x 1/2" Phillips pan tapping screws (U) and
					two #10 x 1" Phillips pan tapping screws (V) to free top cover
					(C) and expose pitch adjustment screw. (See Figure 21)
			2.	Remove lower cover (D) from PRJ-WALLKIT-11. (See
					Figure 21)
	2					1	(V) x 2
				1		(U) x 2
	Figure 19
Roll Adjustment
1.	Loosen ROLL adjustment locking screw using a #2 Phillips
	screwdriver. (See Figure 20)
2. Turn ROLL micro-adjustment screw right or left using a #2
	Phillips screwdriver until image is properly aligned on target.
	(See Figure 20)				(C)
3.	Tighten ROLL adjustment locking screw using a #2 Phillips
	screwdriver. (See Figure 20)					1
							(D)
							2

Figure 21

Visit the InFocus support site at www.infocus.com/support 11