Installation Instructions

PRJ-WALLKIT-11

3.(Optional) Cables can be tied to inside of projector’s front cover using cable ties (not included). Route cables near front cover and wrap cable tie through slots on front cover and around cables. (See Figure 25)

 

Cable tie (not included)

3

Route through slots

and around cables

 

Figure 25

4.Replace removed cable management covers (if necessary). Insert one side of cover into groove and press firmly on the cover on the other side until it snaps into the other groove. (See Figure 26)

(projector not shown)

4

Figure 26

5.Return outer covers to the mount following instructions in Installing Mount Covers section.

Extension Adjustment

1.Loosen two bolts holding stop bracket in place on underside of short throw projector mount. (See Figure 27)

2.Adjust mount to desired extension length. (See Figure 27)

3.Tighten two bolts holding stop bracket to secure mount in desired position. (See Figure 27)

 

1

3

 

2

 

(projector not shown)

Stop bracket

 

Figure 27

Security Screw Installation (Optional)

1.Remove two #8 x 1/2" Phillips screws (U) and two #10 x 1" Phillips screws (V) from top and lower covers. (See Figure 28)

2.Install two 8-32 x 1/2" buttonhead security screws (J) and two 10-24 x 1" buttonhead security screws (M) into top and lower covers. (See Figure 28)

 

 

1

(V) x 2

1

(U) x 2

 

 

 

 

2

 

(M) x 2

2

(J) x 2

 

 

Figure 28

Visit the InFocus support site at www.infocus.com/support

13

Page 13
Image 13
InFocus infocus single stud short throw wall mount manual Extension Adjustment, Security Screw Installation Optional