InFocus infocus single stud short throw wall mount manual Side view

Installation Instructions PRJ-WALLKIT-11

5.Install three 5/16 x 2-1/2" hex head lag screws (P) through three 5/16" washers (Q), inner holes of wall bracket (B) and into drilled holes. (See Figure 4)

5.Hold metal channel on anchor (H) flat alongside plastic straps and slide channel through hole. (See Figure 6)

5	(P) x 3
	(Q) x 3
	(B)

Figure 4

Steel Studs

IMPORTANT ! : See Site Requirements section before proceeding with Steel Studs installation to ensure installation site meets requirements! The drywall must have a minimum thickness of 1/2"!

1.Determine mounting location on wall. Use stud finder to locate steel studs.

2.Line up inner three holes on wall bracket (B) with center of stud at desired mounting location. (See Figure 5)

3.Using wall bracket (B) as a template, mark three holes at inner three holes in bracket. (See Figure 5)

4.Drill three 1/2" holes at marked locations in wall. (See Figure 5)

(B)

3

x 3

4

Steel stud

Figure 5

Drywall
Plastic Straps	5
(H) x 3

Figure 6

6.Holding plastic straps on anchor (H), pull anchor away from wall until channel rests flush behind wall making sure anchor channel is positioned vertically on stud. (See Figure 7)

7.Slide plastic cap on anchor (H) towards wall until flange of cap is flush with wall. (See Figure 7)

(side view)	Steel Stud
	Drywall
Plastic Cap
	6
	7
(H) x 3
Anchor Metal Channel

Figure 7

8.Snap off plastic straps on anchor at wall by pushing side to side, snapping off straps level with flange of plastic cap. (See Figure 8)

9.Repeat Steps 5 through 8 for each mounting hole.

(side view)	Steel Stud
	Drywall
8	Plastic Cap
Plastic Straps
Anchor Metal Channel

Figure 8

Visit the InFocus support site at www.infocus.com/support 7