Ingersoll-Rand 67161-() PROGRAMMING continued, Pressdisplayremarks, Prog Setting The Relays

PROGRAMMING (continued)

PRESSDISPLAYREMARKS

STEP

6

PROG

SETTING

THE

RELAYS

	PROG
	PROG
	PROG
	PROG
			This section sets up the relay information.
	PROG
			Press the ``PROG￿ key to choose ``TOT￿ (relay B assigned
		or	to total) or ``PREW￿ (relay B assigned to prewarn). Press
			``enter￿ when the desired choice is displayed.
	ENTER
		## ##	This will only appear if ``TOT￿ is selected. This is the dura:
			tion (.01 - 99.99 seconds) that relay ``B￿ will remain ener:
			gized. If 00.00 is selected, the relay will latch until reset.
	ENTER
			PRE A = Preset A (batch amount). The set point at which
SETTING		followed by	output ``A￿ will drop out after started. If the displayed value is
THE	PRE A	last PRE A	not the desired preset, press the key(s) under the digit to be
PRESETS		entered	changed.
			PRE B = Preset B
			a) tot selected	The set point at which output ``B￿ will en:
	PROG			ergize.
			b) PrEw selected	The number of counts before batch ends
				that output ``B￿ will drop out.
			If the displayed value is not the desired preset, press the
			key(s) under the digit to be changed.
		flashes	Key in the lock code (see programming step 4) by pressing
SETTING			the keys under the digits to be changed. Press the ``enter￿
		followed by:
			key to enter the displayed code.
THE
	LOCK
LOCK
STATUS			After the code is entered, the unit will display ``LOC￿ (unit
		or	is locked) or ``UN LOC￿ (unit is unlocked). This message will
			be displayed for approximately 3 seconds before the unit re:
	ENTER		turns to the run mode.

PAGE￿￿6 OF 8 67161(X