Ingersoll-Rand 67277-X manual For Diaphragm Pumps, Solenoid Actuated Pump Kits, Operator’S Manual

OPERATOR’S MANUAL		67165-X
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE		67166-X
SOLENOID ACTUATED PUMP KITS		67277-X
		RELEASED: 3-6-98
FOR DIAPHRAGM PUMPS		REVISED: 3-7-06
		(REV. G)
SOLENOID ACTUATED PUMP KITS	GENERAL DESCRIPTION

67165-( ) for 3/8" and 1/2" diaphragm pumps, as follows:

66605X-X, PD03P-X-X, PD05P-X-X, PD05P-X-X-B, PD05R-X-X-B and PM05P-X-X-A02.

67166-( ) for 1", 1-1/2" and 2" non-metallic diaphragm pumps as follows: 6661AX-X-C, 6661BX-X-C, 6661TX-X-C, 6661UX-X-C, 6662AX-X-C and 6662BX-X-C.

67166-( ) for 1" and 1-1/2" metallic diaphragm pumps as follows: 66610X-X-C, 66611X-X-C, 66612X-X-C, 66613X-X-C, 66615X-X-C, 66616X-X-C, 66617X-X-C and 66618X-X-C.

67277-( ) for 2" and 3" metallic diaphragm pumps as follows: PD20A-X-X, PF20A-X-X, PM20A-X-X-A02, PD30A-X-X-B and PM30A-X-X-B02.

ARO solenoid actuated diaphragm pump kits allow the cycle rate of the pump to be controlled electronically. When the solenoid is energized, the pump strokes and dispenses the fluid in one chamber. When the sole- noid is de-energized, the pump strokes in the opposite direction, dis- pensing the fluid in the other chamber.

By providing continuous ON - OFF signals to the solenoid, the fluid transfer rate may be increased or decreased remotely.

Some parts of the pump must be replaced with those included in these kits to enable solenoid actuation.

67165-( ) SOLENOID KIT INSTALLATION

3/8” AND 1/2” DIAPHRAGM PUMPS

Refer to figure 1.

1.Remove (134) bolts from the major valve and remove (135) valve block.

2.Remove (136) plug and replace with 93909 or 96462 plug.

3.Place 94640 plug in pilot hole.

4.Attach (135) valve block to (101) motor body, using (133) washers and (134) bolts. NOTE: Torque to 15 - 20 in. lbs (1.7 - 2.3 Nm).

5.Thread CAT33P-( )-( ) valve assembly into air supply port.

6.Connect CAT33P-( )-( ) valve with 93909 plug, using 94981-XXX-X tube.

Identification dot this side.
				132
135				141 k
~ Valve				140
(see table)
~ 676				96214-2 ~
~ 59756-4
~ 90351				94640 ~
133
. 134				Y325-125 ~
136				~ Y325-29
~ 94981-XXX-X				93909 ~
(5" long) g
				59756-4 ~
NOT SHOWN				~ 96462
CHW Connector
k Assemble with 2 identification dots toward (132) gasket.	MODEL	VALVE	VOLTAGE	~ 59756-4
.Torque to 15 - 20 in. lbs (1.7 - 2.3 Nm).	67165-1 CAT33P-024-D		24 VDC
~ Supplied with 67165-( ) Kit.
	67165-2 CAT33P-120-A		120 VAC
Z See page 4 for coil options.
	67165-3	CAT33P-000-N	No Coil Z
g 94981-XXX-X Bulk Tubing (100’ long).				Figure 1

INGERSOLL RAND COMPANY LTD

P.O. BOX 151 D ONE ARO CENTER D BRYAN, OHIO 43506-0151

& (800) 276-4658 D FAX (800) 266-7016 E2006 CCN 99711780