Insignia 105SX manual What YOU see ON-SCREEN, What You See On-Screen

USING THE 105SX

WHAT YOU SEE ON-SCREEN

If you are using the 105SX in Simulator when no transducer is connected, any selected options are lost when the unit is powered off. The 105SX will return to Factory Settings, or options selected when last used with a transducer, if no transducer is connected.

IMPORTANT: A transducer must be connected to the 105SX in order to retain user settings selected when in simulator mode. If no transducer is detected, the unit defaults to pre-selected options when powered off.

What You See On-Screen

Figure A

Your 105SX uses a 128 x 64 matrix FSTN LCD display. This display provides outstanding viewability in all light conditions over a wide range of temperatures.

At initial power-up, the 105SX uses settings that were set at the factory. After initial use, the 105SX will remember the settings you enter.

There are several elements on-screen that are common to all modes of operation.

Speed/Temperature. The initial screen layout takes one of two basic forms depending on presence of accessories such as Temperature or Speed/Temperature sensors. Figure A shows the default view when the Speed/Temp or Temperature accessory is installed. Figure B shows the default view when no accessory is installed.

Depth. The digital depth number shows the water depth directly beneath the transducer location.

Depth Range. The depth range is shown to the right of the screen. The upper number is 0 indicating the surface of the water. The lower number is one of the nine depth ranges available that best match the depth of the water. As the depth of the water changes, the range changes as necessary in order to retain a bottom representation on-screen.

8