Using the remote control holder | Searching for your code |
Your TV comes with a remote control holder you can put the remote control in when you are not using it. You can put the holder on a table or mount it on a wall.
Screws (not |
|
| Tape |
included) |
|
| |
|
|
| |
|
|
|
|
Note
Different types of walls may require different types of screws. If you want to wall mount the remote control holder, make sure that you use the correct screws for the type of wall. (Screws are not provided.)
Programming your universal Insignia remote control
To program your remote to control home theater devices, follow these steps.
To program your remote control:
1Find the codes for the devices you want to program in “Manufacturers’ codes” on page 45 and write them down or highlight them.
2Turn on the device (for example, a DVD player) and, if needed, load media such as a DVD.
3Press the device button on the TV remote for the device that you want to program (TV, DVD, STB, or AUX).
4Press and hold SET until the red LED blinks twice, then release.
5Enter the first
Note
If the LED does not blink twice, repeat steps 2 to 4 and try entering the code again.
6Aim the remote at the device and press
(power). The device should turn off. If it does not, repeat Steps 3 through 5, trying each code for your brand until you find one that works. If you cannot find a code that works, see “Searching for your code” below.
7Repeat Steps 1 to 5 for the other devices you want to control. For future reference, write down each working device code.
If your device does not respond to the remote control after trying all codes listed for your brand, or if your brand is not listed, try searching for your code.
To search for your code:
1Turn on the device you want to control.
2Press the device button on your TV remote control (TV, DVD, STB, or AUX) once.
3Press and hold SET until the red LED blinks twice, then release.
4Enter 9 9 1. The LED blinks twice.
5Press the number that matches your device type.
•
•
•
•
6Aim the remote at the device and press
(power). The remote sends IR codes from its library to the selected device, starting with the most popular code first. If the device responds, go to Step 8.
7If the device does not respond, press CH 
and the remote tests the next code for that device
type. Continue to press CH 
until the device turns off.
Note
Press CH 
to try the previous code.
8Now that you have found the correct code, press SET to save the code that worked for your device. The LED blinks twice to indicate that the code has been saved.
9To search for other device codes, repeat Steps 1 to 8.
Checking the codes
If you have set up the remote using the procedure in “Searching for your code” on page 10, you may need to find out which
To find out which code is assigned to your TV (for example):
1Press TV once.
2Press and hold SET until the red LED blinks twice, then release.
3Enter 9 9 0. The LED blinks twice.
4To view the code for the first digit, press 1. Count the red LED blinks (for example, three blinks = 3), then write down the number in the appropriate code listing at the top of this column.
Note
If the LED does not blink, the code digit is 0.
5 Repeat Step 4 for the four remaining digits, using 2 for the second digit, 3 for the third digit, 4 for the fourth digit, and 5 for the fifth digit.
10 | www.insigniaproducts.com |