Insignia
Warning
Make sure that you turn off and unplug your TV before installing devices.
Use the following illustration to connect a computer to your TV.
Back of TV
Using your TV
Turning your TV on and offTo turn on your TV:
1Make sure that the power cord is connected to your TV and an electrical outlet.
2Press the 
button to turn on your TV.
3Press the 
button again to turn off your TV
To select the TV source:
1Press the MENU button.
2Press the 
or 
button one or more times to highlight Setup, then press the OK or 
button to open the Setup menu.
Audio cable
D SUB cable
Computer
To watch TV on your computer monitor:
1Turn on your TV.
2Press the INPUT button one or more times to select VGA.
3Turn on your computer, then set up your computer for external VGA input. See your computer documentation for more information.
3Press the 
or 
button one or more times
to highlight Tuning Band, then press the OK or 
button to access the tuning band options.
4Select Air for an outside antenna. Select Cable, Cable HRC, Cable IRC, or Cable Auto for cable TV. We recommend that you select Cable Auto for cable TV. For more information about cable TV selections, contact your cable TV provider.
5Press the EXIT button to close the
After you select your TV source (antenna or cable), you need to set up the channel list. When you set up your channel list, your TV searches for all available channels in your area and stores a list of the channels. When your press the CH 
or 
on the front of your TV or the CH – or + button on the remote control, your TV skips the channels that do not have a signal.
14 |