NS-L42Q120-10A/NS-L46Q120-10A 42"/46" LCD TV

Selecting the sound mode or audio language

• Audio Language—Selects the default

 

language track when watching digital TV

To select the sound mode in analog TV mode:

programs. You can select English,

• Press SAP one or more times to select a sound

Français, and Español. Languages must

mode. You can select

be provide by the broadcaster.

• Mono —Select this option if there is noise or

• MTS/SAP—Select the default language

static from a weak broadcast signal.

stream when watching analog or digital TV

• Stereo—Select this option for programs

channels. For more information, see

“Selecting the sound mode or audio

broadcast in stereo sound.

language” on page 25.

• SAP—Select this option to listen to an

• Reset Audio Settings—Resets the audio

alternative audio language (if available).

settings to the defaults.

 

To select an audio language in digital TV mode:

•Press SAP one or more times to select an audio language (if available).

Adjusting audio settings

To adjust audio settings:

1Press MENU. The on-screen menu opens.

2Press or to highlight AUDIO, then press ENTER. The Audio menu opens.

3Press or to highlight an option, then press ENTER. You can select:

•Equalizer—Sets the audio frequency response to the optimum level. When turned on, the Bass and Treble settings are replaced with:

•Equalizer Mode—Selects one of the preset EQ modes.

•Equalizer Settings—Adjusts the EQ settings.

•Treble—Adjusts the high sounds. When the Equalizer setting is turned off, you can press AUDIO to access the Treble setting.

•Bass—Adjust the low sounds. When the Equalizer setting is turned off, you can press AUDIO to access the Bass setting.

•Balance—Adjusts the balance between the left and right audio channels.

•Auto Volume—Applies the audio settings to both digital and analog channels.

•Advanced Audio—Highlight this option, then press ENTER to access advanced audio settings.

•Digital Audio/SPDIF—Selects the preferred audio format for digital audio signals. This feature is only available on digital channels or when using an HDMI device. You can select PCM or RAW.

4Press or to highlight a setting option, then press ENTER.

Or,

Press or to adjust a setting level, then press

ENTER.

5Press MENU to return to the previous menu, or press EXIT to close the menu.

Playing audio only

To play audio only:

1Press MENU. The on-screen menu opens.

2Press or to highlight CHANNEL, then press ENTER. The Channel menu opens.

3Press or to highlight Auto Only, then press

ENTER.

4Press or to highlight On or Off, then press

ENTER.

5Press MENU to return to the previous menu, or press EXIT to close the menu.

Changing channel settings

Note

Unless otherwise noted, all tasks in this section are based on using the remote control.

Automatically scanning for channels

You do not need to scan for channels unless:

•The channels in your area have changed since you ran the Setup Wizard.

•You change the TV signal source. For example, you change from an antenna to cable TV.

To automatically scan for channels:

1Press MENU. The on-screen menu opens.

2Press or to highlight CHANNEL, then press ENTER. The Channel menu opens.

www.insigniaproducts.com

25