Aiming the remote control | Programming your remote control |
Point the remote control towards the remote sensor on the front of your TV. The remote control should be used within 26 feet (7.9 m) of your TV when you point the remote control directly at the remote sensor and not from an angle. If you use the remote control at an angle to the remote sensor, the effective distance may be less.
To program your remote to control home theater devices, follow these steps.
To program your remote control:
1Before proceeding, find the codes for the devices you want to program in “Manufacturers’ codes” on page 38 and write them down or highlight them.
2Turn on the device (for example, a DVD player) and, if needed, load media such as a DVD.
3Press the device key on the remote for the device that you want to program (TV, DVD, STB, or AUX).
4Press and hold SET until the red LED blinks twice, then release.
5Enter the first
Note
If the LED does not blink twice, repeat steps 2 to 4 and try entering the code again.
Using the remote control holder
Your TV comes with a remote control holder you can put the remote control in when you are not using it. You can put the holder on a table or mount it on a wall.
Screw
Screw
Tips
Different types of walls may require different types of screws. If you want to wall mount the remote control holder, make sure that you use the correct screws for the type of wall. (Screws are not provided.)
6Aim the remote at the device and press
(power). The device should turn off. If it does not, repeat Steps 3 through 5, trying each code for your brand until you find one that works. If you cannot find a code that works, see “Searching for your code” below.
7Repeat Steps 1 to 5 for the other devices you want to control. For future reference, write down each working device code.
Searching for your code
If your device does not respond to the remote control after trying all codes listed for your brand, or if your brand is not listed, try searching for your code.
To search for your code:
1Turn on the device you want to control.
2Press the desired device key (TV, DVD, STB, or AUX) once.
3Press and hold SET until the red LED blinks twice, then release.
4Enter 9 9 1. The LED blinks twice.
5Press the device group number for your device type (see table below).
•
•
•
•
6Aim the remote at the device and press
(power). The remote sends IR codes from its library to the selected device, starting with the most popular code first. If the device responds, go to Step 8.
www.insigniaproducts.com | 9 |