Insignia NS-R2001 Maintaining, Troubleshooting, Using the sleep timer, Adjusting the display brightness, SLEEP, DIMMER, Problem, Category, Possible Solution

Insignia NS-R2001 AM/FM Stereo Receiver

Using the sleep timer	• ON
The sleep timer automatically turns the receiver off	• dimmer
	• OFF
after a specified period of time.
To use the sleep timer:	Note
		If the display is off, pressing any button turns the
• Press the SLEEP button to specify the amount of
		display on.
time you want the receiver to play.

Each time this button is pressed, the time changes as follows:

•10 minutes

•20 minutes

•30 minutes

•60 minutes

•90 minutes

•OFF

Note

While operating the sleep timer, the lights up.

Adjusting the display brightness

To adjust the display brightness:

•Press the DIMMER button to specify the brightness of the display.

Maintaining

To clean this receiver, wipe with a soft, dry cloth. If the surfaces are extremely dirty, use a soft cloth dipped in a soap and water solution or a weak detergent solution.

•Never use alcohol, paint thinner, or benzine to clean this receiver.

•Before using a chemically treated cloth, read the instructions that came with the cloth carefully.

Troubleshooting

If a problem occurs, run through the table below before contacting Insignia.

If the problem persists, attempt to solve it by switching the receiver off and on again. If this fails to resolve the problem, contact Insignia. Under no circumstances should you attempt to repair the receiver yourself as this could void the warranty.

Category	Problem		Possible Solution
No power	• The AC power cord is		• Connect the cord securely.
		disconnected.	• Check the outlet using a lamp or
	• Poor connection at AC			another appliance.
		wall outlet or the outlet
		is inactive.
No sound	• The speaker cords are		• Check the speaker connections.
		disconnected.	•	Adjust the volume.
	• The volume is adjusted		• Press the MUTE button to cancel
		too low.		the muting effect.
	• The MUTE button on the		• Turn on one or both speakers.
		remote control is pressed	• Select the desired input source
		to ON.		correctly.
	•	Speakers are not	•	Make connections correctly.
		switched on.
	• Incorrect selection of the
		input source.
	•	Incorrect connections
		between the
		components.
Stationscannot	• No antenna is connected.		•	Connect an antenna.
be received
	•	The desired station	• Tune in the desired station
		frequency is not tuned in.		frequency.
	• The antenna is in wrong		• Move the antenna and retry
		position.		tuning.
Preset stations	•	An incorrect station	• Memorize the correct station
cannot be
		frequency has been		frequency.
received
		memorized.	• Memorize the stations again.
	•	The memorized stations
		are cleared.
Poor FM	• No antenna is connected.		•	Connect an antenna.
reception
	• The antenna is not		• Change the position of the
		positioned for the best		antenna.
		reception.

Each time this button is pressed, the brightness changes as follows:

www.insigniaproducts.com 11