Insignia NS-R2001 AM/FM Stereo Receiver

Category

Continuous hissing noise during FM reception, especially when a stereo broadcast is received.

Continuous or intermittent hissing noise during AM reception, especially at night.

No recording

Remote control unit does not operate.

Problem

Weak signals.

Noise is caused by motors, fluorescent lamps, or lightning.

•Incorrect selection between the components.

•Incorrect operation of each component for playback and recording.

•Batteries are not loaded or are exhausted.

•The remote sensor is obstructed.

Possible Solution

•Change the position of the antenna.

•Install an outdoor FM antenna.

•Keep the receiver away from noise sources.

•Install an outdoor AM antenna.

•Make connections correctly.

•Operate each component correctly.

•Replace the batteries.

•Remove the obstacle.

General

Power supply:

120 V ~ 60 Hz

 

Power consumption:

2.5 A

 

 

 

 

Dimensions (W×H×D, including protruding parts):

 

 

17-3/8×5-1/2×15 inches (440×141×381 mm)

 

 

Weight (Net):

17.4 lbs (7.9 kg)

 

 

 

Legal notices

FCC Part 15

This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Specifications

Notes

•Design and specifications are subject to change without notice.

•Weight and dimensions shown are approximate.

•Specifications and external appearance may be changed for the sake of improvement.

Amplifier

Power output, stereo mode, 8 Ω, THD 1%, 40 Hz~20 kHz:

2×100 W

 

 

 

 

Total harmonic distortion, 8 Ω, 100 W, 40 Hz~20 kHz:

0.04%

 

Intermodulation distortion, 60 Hz:7 kHz= 4:1 SMPTE, 8Ω, 100 W: 0.02 %

 

 

 

 

Input sensitivity, 47 kΩ, Phono (MM):

2.5 mV

 

Input sensitivity, 47 kΩ, Line (CD, AUX1, AUX2):

200 mV

 

 

 

 

Signal to noise ratio, IHF “A” weighted, Phono (MM):

70 dB

 

Signal to noise ratio, IHF “A” weighted, Line (CD, AUX1, AUX2): 95 dB

 

 

 

 

Frequency response Phono (MM), RIAA, 30 Hz~20 kHz:

+/- 3 dB

 

Frequency response Line (CD, AUX1, AUX2), 20 Hz~100 kHz: +/- 3 dB

 

 

 

 

Output level AUX1, AUX2 OUT, 2.2 kΩ:

200 mV

 

Bass/Treble control, 100 Hz/10 kHz:

±10 dB

 

 

 

FM Tuner

Tuning frequency range:

87.5~107.9 MHz

 

Usable sensitivity, THD 3%, S/N 30 dB:

15 dBf

 

 

 

 

50 dB quieting sensitivity, mono/stereo:

25.2 / 45.2 dBf

 

Signal to noise ratio, 65 dBf, mono/stereo:

68/65 dB

 

 

 

 

Total harmonic distortion, 65 dBf,1 kHz, mono/stereo:

0.5 / 0.8%

 

Frequency response, 20 Hz~14 kHz:

+/- 3 dB

 

 

 

 

Stereo separation, 1 kHz:

40 dB

 

Capture ratio:

4 dB

 

 

 

 

IF rejection ratio:

80 dB

AM Tuner

Tuning frequency range:

530~1710 kHz

 

 

 

 

Usable sensitivity:

800 μV/m

 

Signal to noise ratio:

40 dB

 

 

 

 

Selectivity:

25 dB

 

 

 

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced technician for help.

FCC warning

Changes or modifications not expressly approved by the party responsible for compliance with the FCC Rules could void the user’s authority to operate this equipment.

Canada ICES-003 statement

This Class B digital apparatus complies with Canadian ICES-003.

12

www.insigniaproducts.com