InSinkErator 1100 owner manual Preparation, 31⁄8, 37⁄8

If installing ONLY new faucet or new tank, see Page 10.

START HERE PROPER INSTALLATION SHOULD TAKE ABOUT 2-4 HOURS

1		PREPARATION
	A	Required minimum from
		center of hole to wall
		F-HC2215	31⁄8"
		F-GN2215	37⁄8"
		F-HC2200	31⁄8"
		F-GN2200	37⁄8"
		F-HC1100	31⁄8"
		F-GN1100	37⁄8"
		Maximum counter
		thickness is 3".

■Identify locations for the dispenser faucet, tank and filter.

■Check to make sure there is proper clearance for dispenser handles to be fully opened.

■Check to make sure counter is 3" thick or less.

■Make sure there is a grounded electrical outlet under the sink.

The wall outlet for your dispenser must have power supplied to it continuously and must be fused. It should not be controlled by the same wall switch

that operates your disposer, unless using an InSinkErator SinkTop SwitchTM.

B

If you have to drill through sink or

countertop, you may need to rent or purchase

the appropriate tools.

■Turn off water supply.

■If using the sink sprayer hose hole, remove nut that connects sprayer hose at bottom of faucet.

■Using adjustable wrench, remove nut connecting sprayer washer flange in sprayer hole.

■Plug hose opening with either a 1/8" plug or a 1/4" cap (not supplied).

C

Required Hole Size

Hot & Cool Models	13⁄8" - 11⁄2"
Hot Only Models	11⁄4" - 11⁄2"

Consult a professional before drilling into

a surface other than stainless steel.

What if you don’t have a sprayer hole or don’t want to use it?

■Many homeowners replace the soap dispenser in their sink with an instant hot water dispenser.

■If drilling a hole into a stainless steel sink or counter top, you can cut a mounting hole for the dispenser with a hole saw for stainless steel, or you can use a hole punch.

5