Installation of new disposer:
C A U T I O N
CLEAN DRAIN LINE
BEFORE INSTALLING DISPOSER
Failure to clean sink drain line may result in drain line blockage. With drain auger, clear all hardened waste material in horizontal drain line.
10
C
Evenly apply 1/2” thick rope of plumber’s putty around flange
(C).
13 | I |
Optional |
|
Place a weight such as the dis- poser on the sink flange to hold it in place. Use a towel to prevent scratching sink. Pull snap ring open and press firmly until it snaps into place.
11
C
Press flange (C) firmly into sink drain. Remove excess putty.
14 | < 3/8” |
|
E | F |
G
> 3/8”
E
F
H
Tighten 1 1/2” screws (G) evenly and firmly against backup flange. Use shorter 1 1/8” screws (H) if sink is more than 3/8” thick.
12 C
D
E
G
F
Insert fiber gasket (D), backup flange (E) and mounting ring (F). Hold in place while inserting snap ring (I).
Stop
15 & !*
Read
J
*CAUTION: DISHWASHER CONNECTION ONLY If you do not need to attach the dishwasher, go to step 17. Turn disposer (J) onto side and insert screwdriver into dish- washer inlet.
5