WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
■For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing or using this hot water faucet.
■Make sure that all electrical wiring and connections conform to local codes.
■A standard
■The wall outlet powering the tank must have electrical power supplied to it continuously.
■This outlet must be fused and should not be controlled by the same wall switch that operates a food waste disposer, unless you have a SinkTop Switch™ from InSinkErator®.
■If you suspect elevated levels of chlorine in your water, it is recommended to use our water filtration system.
■The use of a water filter should NOT result in the water pressure to drop below 30 psi (207kPa). If it does, this will prevent your unit from operating properly.
■Moving parts inside the tank causing a rattling noise is normal.
WHAT YOU NEED TO GET STARTED
Equipment Required:
■ Cordless Drill | ■ Phillips and flat blade screwdrivers |
■ Compression fitting, | ■ Pencil |
| ■ Tape Measure |
■ Adjustable wrench | ■ Level |
Equipment You May Need:
■ Anchors for drywall | ■ Basin wrench |
■ Hole saw | ■ Hole punch |
If you intend to use the sprayer hole in your sink for your faucet, you may need a basin wrench and a 1/8" plug or a 1/4" cap (not supplied) for the faucet spray hose line. See Step
If you need to cut a mounting hole in your stainless steel sink, you may need a 11⁄4" - 11⁄2" hole saw made for cutting stainless steel or a hole punch. Consult a professional if you are drilling into a surface other than stainless steel.
COMPONENTS IN THIS PACKAGE
3/4" Screws (2) | Lock | Hex Nut | Deck Plate | |
Washer | ||||
|
|
|
UW/UWL | Plastic Mounting Gasket | Metal | Tank | |
Mounting Plate | Fitting (3 pieces) |
2