InSinkErator MS Features/Mounting the Control Center, Introduction, Mounting The Control Center

Features/Mounting the Control Center

INTRODUCTION

The MS Control Center is UL® and CUL® approved for use with InSinkErator Foodservice Disposers. See Table 1 for approved disposer and control center combinations. The control center operates the disposer. Its main functions are:

•To start and stop the disposer.

•To start the water flow to the disposer.

Model	Waste Disposer Model
MS-4	SS50-26, SS75-27, SS100-28, SS125-25,
MS-5	SS150-34, SS150-38, SS200-27, SS200-31
MS-5	SS50-27, SS75-28, SS100-29,
	SS125-26, SS150-36, SS150-39,
	SS200-29, SS200-32, SS300-25, SS300-27,
	SS500-28, SS500-29, SS500-30
MS-6	SS50-27, SS75-28, SS100-29,
	SS125-26, SS150-36, SS150-39,
	SS200-29, SS200-32, SS300-25,
	SS300-27, SS500-28, SS500-30, SS750-13,
	SS750-15, SS1000-10, SS1000-11, SS1000-12
Table 1. Approved Disposer and Control Center Combinations

Model	Part No.	Voltage	Phase	HP
MS-4	14356	120V	1	1/2-2
MS-5	14356A	208-230V	1	1/2-2
MS-5	14356A	208-230V	3	1/2-5
MS-6	14356B	380/460V	3	1/2-10

Table 2. Electrical Specifications

FEATURES

ENCLOSURE

NEMA 4 construction.

PUSH BUTTON OPERATION

Push Green button to start disposer. Push Red button to stop disposer.

MOUNTING THE CONTROL CENTER

Use the flanges at the back of the control center enclosure and only mount panel in the upright vertical position. See Figure 1.

Locate control center within sight of disposer per local codes. Locate any remote control station within sight of disposer per local codes.

If box is mounted to the sink table, recess the box so that the buttons do not extend beyond the table's edge.

Figure 1. Control Center Dimensions

PROPERTY DAMAGE

Use of more than two solenoid valves will affect the overall function of the MS control center. Extra solenoid valves will cause a reduction in voltage and solenoid actuation will not occur.

3