Step 3. FrontWheel Assembly
Turn stroller upright onto its rear wheels, then tip stroller back so the handlebar is down on the ground and the front is up. Slide the front wheel assembly onto the front wheel post, push until the wheel assembly locks into place (Figure C1). Check to see that the wheel assembly is properly inserted by pulling on the wheel firmly. To remove wheel push on release tab and pull off wheel (Figure C2).
To lock the front wheel from turning:
Push down on the front wheel’s lock lever to keep the front wheel from turning. To unlock, lift up on lever (Figure C3).
C1
Front Wheel Post
Front Wheel Assembly
Step 4. Front Fender Assembly
While stroller is still upright on its rear wheels, align the fender’s tabs with the holes in the front frame and press on. Insert the #4 – 16mm screws into the hole and tighten with a Phillips screwdriver, repeat for the other 3 holes (Figure D).
WARNING: To avoid burns, never put hot liquids in the parent or child tray. To prevent tipping over do not place more than 2 lbs. or 1 kg on either parent or child tray.
C2
Front Wheel
Release Tab
C3
Front Wheel
Lock Lever
D
Fender
Tab
Front Frame Fender Holes
4
