Integra DPS-8.3 Press and hold down the button on, Other remote control unit that

Programming the Commands of Other Remote Control Units into the Remote Controller

Programming procedure

4	Press and hold down the button on
	the other remote control unit that
	corresponds to the command you
	want to program until the Send/
	Learn indicator flashes twice to
	indicate that the command has
	been successfully programmed.
	After flashing twice, the Send/Learn
	indicator lights up again.
5	Repeat steps 3 and 4 to program
	other commands within the same
	mode. Repeat step 2 to 4 to
	program commands to the other
	mode.
6	Press the Mode button (VCR or TV)
	that you pressed in step 2 to
	complete the programming.
7	Use the remote controller to
	perform the newly learned

command to confirm that it was learned correctly.

Notes

•Some buttons have already been programmed to control functions of an Integra/Onkyo receiver. Therefore, it is recommended to program additional functions of the receiver that are not already programmed in the remote controller.

•If no buttons are pressed for more than 30 seconds during the programming, or if you perform an invalid operation, the Send/Learn indicator flashes three times quickly and the remote controller exits the programming mode. Resume programming from step 2.

•If you perform an invalid operation during programming, the Send/Learn indicator flashes three times quickly and the remote controller exits the programming mode. Resume from Step 2.

•When you want to program a command to a button to which you have already programmed a command, simply follow the same procedure and programming for that button will be overwritten.

•The remote controller uses infrared rays to send its commands, as do most other remote control units. Though most remote control units can be memorized by the remote controller, be aware that some remote control units use a system that is quite different from the remote controller and therefore may not be able to be programmed.

•Some remote control units have a single button that performs multiple functions (for example, the function may change each time the button is pressed). If this is the case, each function must be programmed to a separate button on the remote controller.

•Once you have programmed the commands from the other remote control unit, refer to the instructions supplied with the other component to operate.

•Make sure that both the remote controller and the other remote control unit have new batteries. If either of them has batteries that are low, you may not be able to program the commands of the other remote control unit properly into the remote controller.

•Removing the batteries from the remote controller for at least 10 minutes erases all of the commands that have been programmed in the remote controller.

66