User Guide XB1 COM Express Module
Connectors
Caution
Some of the internal connectors provide operating voltage (3.3V and 5V) to devices inside the system chassis, such as internal peripherals. Not all of these connectors are overcurrent protected. Do not use these internal connectors for powering devices external to the computer chassis. A fault in the load presented by the external devices could cause damage to the board, the interconnecting cable and the external devices themselves.
PLD Programming Header ISPCON
This pin header is the programming port for the
ISPCON
1 |
| 240.1.08.I |
|
| © EKF |
| |
|
| ekf.com |
|
|
|
|
|
1=3.3V | 2=Serial Out | 3=Serial In | 4=ispGAL Enable |
5=NC | 6=Mode | 7=GND | 8=Clock |
©EKF | ekf.com |
