A Error Messages and Indicators
Desktop board D945GPM reports POST errors in two ways:
•By sounding a beep code
•By displaying an error message on the monitor
BIOS Beep Codes
The BIOS also issues a beep code (one long tone followed by two short tones) during POST if the video configuration fails (a faulty video card or no card installed) or if an external ROM module does not properly checksum to zero. Table 12 lists the BIOS codes.
Table 12. | Beep Codes | |
|
|
|
Beep |
| Description |
|
|
|
3 |
| No memory |
|
|
|
Siren |
| CPU overheat (on reboot) |
|
|
|
BIOS Error Messages
When a recoverable error occurs during the POST, the BIOS displays an error message describing the problem. Table 13 gives an explanation of the BIOS error messages.
Table 13. BIOS Error Messages
Error Message | Explanation |
|
|
PROCESSOR_THERMAL_TRIP_ERROR | CPU was previously shutdown due to a thermal event |
| (overheating). |
|
|
MULTI_BIT_ECC_ERROR | The firmware has detected that a |
|
|
SINGLE_BIT_ECC_ERROR | The firmware has detected that a |
|
|
CMOS_BATTERY_ERROR | The firmware has detected that a CMOS battery failure occurred. |
|
|
CMOS_CHECKSUM_ERROR | The firmware has detected that a CMOS Checksum Error |
| occurred. |
|
|
CMOS_TIMER_ERROR | The firmware has detected that the system date/time has not |
| been set. |
|
|
MEMORY_SIZE_DECREASE_ERROR | The firmware has detected that the system memory has |
| decreased. |
|
|
INTRUDER_DETECTION_ERROR | The system chassis was opened. |
|
|
SPD_TOLER_ERROR | SERIAL PRESENCE DETECT (SPD) device data missing or |
| inconclusive. Properly programmed SPD device data is required |
| for reliable operation. DDR2 533 MHz memory assumed at |
| slowest timings. |
|
|
MEM_OPTIMAL_ERROR | The installed amount of memory in Channel A is not equal to the |
| amount of memory in Channel B. Maximum memory |
| performance is achieved with equal amounts of memory installed |
| in each channel. |
|
|
63
