NOTE
See the
Change speed button and LEDs
You can determine the speed of the connection between the Ethernet Module and device from the speed LEDs. Use the Change speed button to cycle among speed settings.
Attach any Express 10/100 Stackable Hub to the Ethernet Module and the module will automatically negotiate the correct speed. The default speed setting is
LED | Status | Meaning |
Solid | Module is set to | |
| Blinking | Module is being forced to cycle among |
|
| 10 Mbps, and 100 Mbps. |
| Off | Speed has been forced to 100 Mbps or 10 Mbps. |
|
|
|
100 Mbps | Solid | Module is running at 100 Mbps. |
| Blinking | Module is being forced to cycle among |
|
| 100 Mbps, and 10 Mbps. |
| Off | Module is not running at 100 Mbps. |
|
|
|
10 Mbps | Solid | Module is running at 10 Mbps. |
| Blinking | Module is being forced to cycle among |
|
| 100 Mbps, and 10 Mbps. |
| Off | Module is not running at 10 Mbps. |
|
|
|
NOTE
A long press is held for 2 seconds or more.
A short press is held for less than 2 seconds.
To change the speed
This example forces the speed to 100 Mbps:
1Long press the Change speed button. The
2Short press the Change speed button. The 100 Mbps LED blinks.
3Long press the Change speed button. The 100 Mbps LED stays on solid.
Coll (collision) LED
The Coll (collision) LED blinks amber when collisions are detected and is unlit when no collisions are occurring.
11