NOTE
A long press is held for 2 seconds or more.
A short press is held for less than 2 seconds.
Connecting to a device at full-duplex
Express 10/100 Stackable Hubs operate at
Connecting to a switch at full-duplex
Not all device manufacturers implement
To force the duplex mode, use the Change duplex button:
1Long press the Change duplex button. The
2Short press the Change duplex button. The
3Long press the Change duplex button. The
4Configure the device on the other end for full duplex. (See the device’s documentation for specific instructions.)
To force the speed, follow the steps above using the Change speed button.
Example configurations
Connecting to a switch at
|
| Ethernet Module | or | |
|
|
|
| |
Change | Change | Coll | ||
duplex |
| speed |
| |
100 Mbps |
| |||
|
|
| ||
|
| 10 Mbps |
| |
|
|
| MDI |
This is an Ethernet Module plugged into a hub running at 100 Mbps. The module is then connected to a 100 Mbps switch using
CAT 5 TPE cable. The module was forced to run in
7