Intel EE110EM manual Quick Start, Turn off the power before installing

Quick Start

1.Turn off the power, then unscrew and remove the panel from an expansion slot on the Express 10/100 Stackable Hub.

1 2 3 4 5 6 7 8

9

10 11 12

Green	(left)
Link
AmActivity	= blink
	=solid
Wrongber	(right)
Disabledspeed= solidblink=

Expansion slots: Use either slot. They are identical.

Turn off the power before installing.

Intel
10/100Express
10BASE-	Stackablespeed
Change hub		Hub
T
100BASE-TX
	Collision
	Managed
	Status		Power

2.Plug either the Ethernet Module or the Fiber Module into a slot, using the retaining screws to secure the module to the hub.

Ethernet Module

1 2 3 4 5 6 7 8

9

10 11 12

Amber	(right)
Wrong
Disabledspeed= solidblink=

Turn on the power after installing.

Intel
10/100C	Stackablespeed
10BASE-
hange hub		Hub
T
100BASE-TX
	Collision
	Managed
	Status		Power

3. Plug a device in and check the LEDs for a link. You’re done.

		Ethernet Module				or
Change	Auto-negotiate	Change	Auto-negotiate			Coll
duplex		speed
	Full-duplex		100 Mbps
	Half-duplex		10 Mbps
					MDI	MDI-X
		Fiber Module
	Auto-negotiate		Xmt	Link
Change
duplex	Full-duplex
	Half-duplex
			Rcv	Coll	TX	RX

Xmt Link

Rcv Coll

Solid green indicates link. Blinking green indicates activity. If you don’t get a link, try the other port.

The LEDs light for both ports, even though you can use only one port at a time. This is normal.

Solid green indicates link. The Xmt LED blinks when data is transmitted. The Rcv LED blinks when data is received.

1