Intel IB935 user manual Installing the Memory, DDR2 Module Lock

INSTALLATIONS

Installing the Memory

The IB935 board supports two DDR2 memory sockets for a maximum total memory of 4GB in DDR2 memory type. It supports DDR2 667/800.

Basically, the system memory interface has the following features: Supports two 64-bit wide DDR data channels

Available bandwidth up to 6.4GB/s (DDR2 800) for single-channel mode and 12.8GB/s (DDR2 800) in dual-channel mode.

Supports 256Mb, 512Mb, 1Gb DDR2 technologies. Supports only x8, x16, DDR2 devices with four banks Supports only unbuffered DIMMs

Supports opportunistic refresh

Up to 32 simultaneously open pages (four per row, four rows maximum)

Installing and Removing Memory Modules

To install the DDR2 modules, locate the memory slot on the board and perform the following steps:

1.Hold the DDR2 module so that the key of the DDR2 module align with those on the memory slot.

2.Gently push the DDR2 module in an upright position until the clips of the slot close to hold the DDR2 module in place when the DDR module touches the bottom of the slot.

3.To remove the DDR2 module, press the clips with both hands.

Lock

DDR2 Module Lock

Lock

Lock

IB935 User’s Manual 7