C.1 DiskOnChip® 2000 Quick Installation Guide

C.1.1 DiskOnChip 2000 installation instructions

1.Make sure the target platform is powered OFF.

2.Plug the DiskOnChip® 2000 device into its socket. Verify the direction is correct (pin 1 of the DiskOnChip® 2000 is aligned with pin 1 of the socket).

3.Power up the system.

4.During power up you may observe the messages displayed by the DiskOnChip® 2000 when its drivers are automatically loaded into the system's memory.

5.At this stage the DiskOnChip® 2000 can be accessed as any disk in the system.

6.If the DiskOnChip® 2000 is the only disk in the system, it will appear as the first disk (drive C: in DOS).

7.If there are more disks besides the DiskOnChip 2000, the DiskOn- Chip® 2000 will appear by default as the last drive, unless it was programmed as the first drive. (Please refer to the DiskOnChip® 2000 utilities user manual.)

8.If you want the DiskOnChip® 2000 to be bootable:

a . Copy the operating system files into the DiskOnChip® by using the standard DOS command (for example: sys d:).

b . The DiskOnChip® should be the only disk in the systems or would be configured as the first disk in the system (c:) using the DUPDATE utility.

DUPDATE

D

/S:

DOC104.EXB /FIRST

(set as c:)

DUPDATE

C

/S:

DOC104.EXB

(set as d:)

60PCA-6175 User's Manual

Page 70
Image 70
Intel PCA-6175 manual DiskOnChip 2000 Quick Installation Guide, DiskOnChip 2000 installation instructions