Chapter 6 PCI Bus Ethernet Interface
6.1 Introduction
The PCM-3370 is equipped with a high-performance 32-bit Ethernet chipset which is fully compliant with IEEE 802.3 100 Mbps CSMA/CD standards. It is supported by major network operating systems. It is also both 100Base-T and 10Base-T compatible. The medium type can be con- figured via the PQ8139.exe program included on the utility disk.
The Ethernet port provides a standard RJ-45 jack. The network boot fea- ture can be utilized by incorporating the boot ROM image files for the appropriate network operating system. The boot ROM BIOS files are combined with system BIOS, which can be enabled/disabled in the BIOS setup.
6.2 Installation of Ethernet Driver
Before installing the Ethernet driver, note the procedures below. You must know which operating system you are using in your PCM-3370, and then refer to the corresponding installation flow chart. Then just follow the steps described in the flow chart. You will quickly and successfully complete the installation, even if you are not familiar with instructions for MS-DOS or Windows.
. | |
Note: | The windows illustrations in this chapter are |
| examples only. You must follow the flow chart |
| instructions and pay attention to the instructions |
| which then appear on your screen. |
6.2.1 Installation for MS-DOS and Windows 3.1
If you want to set up your Ethernet connection under the MS-DOS or Windows 3.1 environment, you should first check your server system model. For example, MS-NT, IBM-LAN server, and so on.
Then choose the correct driver to install in your panel PC.
The installation procedures for various servers can be found on CD- ROM. The file path begins as: D:\LAN\8139C\drive\wfw311
