2.5 Installing SO-DIMM

 

 

Module Key Aligned

 

 

With housing Key

 

2

Housing

 

 

 

 

Card Slot

PC Board

 

 

1

 

 

Module Tilted

 

3

Approximately 25

 

 

Module Latching

Ledge(TO Engage

Edge of Module)

The procedures for installing SODIMMs are described below. Please fol- low these steps carefully. You can install SDRAM memory modules using 200-pin SODIMMs (Small Outline Dual In-line Memory Modules).

1.Ensure that all power supplies to the system are switched off.

2.Tilt the SODIMM card approximately 25o above the board, and move it in the direction of the housing card slot. Make sure that the key in the module and the key in the housing are aligned.

3.Push the module into the socket until the module bottoms. There should be a slight insertion force to engage the module into the contacts.

2.6IDE, CDROM hard drive connector (CN6)

The board provides 1 IDE channels which you can attach up to two Enhanced Integrated Device Electronics hard disk drives or CDROM to the board’s internal controller. Its IDE controller uses a PCI interface. This advanced IDE controller supports faster data transfer, PIO mode 3, mode 4 and up to UDMA/33.

15

Chapter2

Page 27
Image 27
Intel PCM-9387 user manual Installing SO-DIMM, IDE, Cdrom hard drive connector CN6