Intel SRCSATAWB Intel RAID Controller Srcsatawb Characteristics, Jumper Description Type Comments

3Intel® RAID Controller SRCSATAWB Characteristics

J7		Embedded RAM	J1 J2		J3	Speaker
								J6
								J5
								J8,
								ports 3 - 0
								J9,
								ports 7 - 4
				LSI* 1078 ROC			J10
	Battery Mount Points							AF002341

Jumper	Description	Type	Comments
J1	Dirty cache LED	2-pin	Provides signal to indicate cache needs to write
	header	header	data.
J2	On-board BIOS	2-pin	Default is for no jumper
	enable	jumper
J3	Serial UART port	4-pin	Debug use only
		header
J5	Drive fault LEDs	8x2 header	LED signal for drive fault per port for eight ports
			(not available through expander)
J6	I2C header (SES2)	3-pin	Enclosure management support (usually a non-
		header	expander hot-swap backplane)
J7	Battery connector	Daughter	Connector used for optional battery backup pack
		card
		connector
J8	Internal SAS/SATA	SFF8087	For ports 0 - 3
	port connector
J9	Internal SAS/SATA	SFF8087	For ports 4 - 7
	port connector
J10	Firmware recovery	2-pin	This jumper needed only for flashes if the firmware
	jumper	jumper	is corrupted. The card does not function as a
			controller if this jumper is in place.

Figure 4. Card Layouts

Intel® RAID Controller SRCSATAWB Hardware User’s Guide 10