Intel TM700 manual Installing or Removing a 3.5-inch Floppy Disk Drive

TM700 User Guide - Upgrading Your System

Installing or Removing a 3.5-inch Floppy Disk Drive

This section describes how to remove, replace and add 3.5-inch Floppy Disk Drives (FDDs). Two 3.5-inch floppy disk drives can be installed in the FDD bracket. If a floppy disk drive was installed into your system at the factory, it is located in the upper slot of the bracket.

Removing a 3.5-inch Floppy Disk Drive

To remove the floppy disk drive from the upper 3.5-inch slot of the 3.5/5.25-inch bracket:

1.Remove the right side door. See “Removing the Right Side Door:” on page 6.

2.Remove the front panel. See “Removing the Front Panel:” on page 8.

3.Remove the 3.5/5.25-inch bracket. See “Removing the 3.5/5.25-inch Bracket:” on page 9.

4.Remove the three screws (A) securing the floppy disk drive to the bracket (two on the left side and one on the right side)

Figure 4 - 12 : Removing the Screws

5.Slide the floppy disk drive out of the bracket.

Figure 4 - 13 : Sliding the Floppy Disk Drive out

6.Set the floppy disk drive aside.

4 - 14