![](/images/new-backgrounds/1123584/123584151x1.webp)
TM700 User Guide - Upgrading Your System
2.Remove the front panel. See “Removing the Front Panel:” on page 8.
3.Remove the
4.Through the holes (A - one on each side of the bracket) gently pull the tabs (B) to remove the
Figure 4 - 15 : Removing the Plastic Kit
5.Slide the floppy disk drive into the lower slot of the bracket until the three screw holes (A - two on the left side and one on the right side) are lined up, and secure three screws.
6.Replace the
7.Connect the data cable to the floppy disk drive with the marked edge toward pin 1 of the drive and all cables to the installed 3.5- and
Note: The installation of a second diskette drive requires the replacement of the existing diskette drive data cable with a
8.Connect the power cable to the drive. See “Cabling the Device” on page 32.
9.Replace the front panel. See “Replacing the Front Panel:” on page 8.
10.Replace the right side door. See “Replacing the Right Side Door:” on page 6.
4 - 16